Solar pool water heater panels are usually flat-plate solar
water heating collectors. The best versions of Solar Collectors for pool water
use are often made of top quality raw Copolymer Polypropylene
blended with carbon black, synergistic antioxidants and UV
stabilizers.. Pool water having chlorine is corrosive and is
circulated through the panels using the existing pool filter system or a
supplement one. An automatic temperature controller is used to operate the pump.
The collectors/ panels can be roof mounted near the Swimming pool, or they can
be placed on a ground, on a tilted rack. Due to the low temperature difference
between the air and the water, the panels are often unglazed but are pleasing to
look. The collectors should ideally face South in the northern hemisphere, and
North in the southern.. The Collectors static tilt should be placed in such an
angle that it warms the pool even during the coolest months of the year. The
tilt will vary in regard to latitude .The collectors gravity must be downwards
so as to protect itself from freezing conditions in extremely cold climates.
A simple rule to calculate the panel area needed is around 60% of the pool's
surface area i.e. Length x Breadth ( not the height of the pool ). This
calculation is only applicable for areas where swimming pools are used in the
summer season only, not for the year round. Installing solar collectors to a
outdoor swimming pool, in a cold climate, can typically extend the swimming
season by a couple of months or more if an insulating pool cover is also used.
However an in depth analysis is required by an expert to maximize the solar pool
heating system before it is built.
Solar energy is Human and Environment Friendly
These days we hear a lot about the damaging effect that burning fossil is having
on the environment. Fuel burnt releases nitrogen oxides that cause smog
formation. Respiratory problems are on the rise due to this smog. Solar energy
helps effectively in reducing the smog. Burning Fuels also produces carbon
dioxide. This carbon dioxide enters our atmosphere and affects climate change.
By using our Solar heating Collectors you can stop three to 10 tonnes of Carbon
dioxide entering the atmosphere each swimming season. So save the Earth!!!
Panels are made from top quality raw Copolymer Polypropylene
blended with carbon black, synergistic antioxidants and UV
stabilizers which are used to form both the absorber tubes
and the one piece injection molded header. High
concentration of carbon black protects our base material for
years and helps it to endure extreme climates conditions and
UV radiation intensity. Each Collector is tested at a
pressure of 200 psi before it is ready for delivery ( Panels
actually experience 40-50 psi only). 2 inches size Headers
for excellent Water Flow. Our collectors are black in color
and have a very pleasing appearance.
|
|
|
![](images/quality_01.jpg) |
Cutting edge Technology
NO WELDING OR JOINING , SO NO CHANCES OF LEAKAGES AND DAMAGE OF ROOFS.
OUR COMPETITORS ARE STILL WELDING WHILE WE ARE MOLDING. One of its kind
in the world the 4 feet Header which is a one piece injection molding,
welding free, hence no chance of leakages from it. Headers are
further molded with the extruded absorbers minimizing the chances of
leakage between the header and the extruded absorber. Indeed A SINGLE
PIECE MARVEL NOT YET THOUGHT OF IN THE SOLAR COLLECTOR INDUSTRY.
|